Mill Room Controls

UL listed (with UL508a label) Mill Room Control Panel with Remote Mount Stop Button including the following. 1. (Qty.1 each) UL NEMA 4X Mill Room Control panel including the following: • Wiring schematic provided DPS based on request received and below assumptions listed • Hardware selection based on supplied control panels following same structure. • Proposal assumes 208/230VAC 3 phase with neutral (for 120VAC) for supply voltage to control panel • Completed control panel to include: o NEMA Type 4x wall mount enclosure with back panel o Main incoming 3 pole Non-fused disconnect switch through the door disconnect handle, and adder block for incoming Neutral wire connection o Roller Mill (RM1) 3hp, 208vac 3ph, 11fla Controls include:  3pole din mount circuit breaker rated at 20amps  16amp starter w/120VAC coil including adjustable overload (11-17FLA)  Green Illuminated Start Push Button  Red Non-Illuminated Stop Push Button • RM1 motor will not run unless Flex Auger AG1 is running o (3 (will be dependent on Flex Auger Qty. selected)) Flex Augers (AG1, AG2, AG3) 3/4hp, 230vac 3ph, 3.5fla Controls include:  (3) 3pole din mount circuit breakers rated at 10amps each  (3) 9amp starters w/120VAC coil including adjustable overload (4- 6.3FLA)  (3) Green Illuminated Start Push Buttons  (3) Red Non-Illuminated Stop Push Buttons o 120VAC Control Function to include:  120VAC Single Pole din mount circuit breaker rated at 10amps  2 position Control Power “OFF-ON” selector switch  120VAC Ice Cube Relay wired for Field installed remote E-Stop to deenergize Control Panel  120VAC White Control Power Pilot Light for Control Power indication  120VAC Red Pilot light for indication of Remote Stop Push Button Pressed • DPS to supply phenolic labeling for door mounted devices based on layout example of previous project. • Control Panel field Terminal block interface for Control Connections • Customer source inspection included if requested prior to delivery. • Completed Control Panel to bare UL508a label BREWHOUSE CONTROL PANEL WITH 1 FLEX AUGER: $4273.28 ADDER OPTION: • DPS to supply for Customer install and wiring (1) Killark Remote Stop (E-STOP) Maintained Mushroom Head Single Hole PUSH-PULL Button Station for Hazardous locations: o Killark Model #FXCS-0MMR3 remote Push-Pull Station (Maintained) o Killark Model #FXB-2 Back Box for Push-Pull Station ADDER OPTION: $594.00 Total price- $4867.28 plus shipping – TBD